Table of Contents
Advertisement
Basic Setup
Step 2 ¡ Ð
Show the Warning message
Note that if you have already enabled
bandwidth management (ADVANCED
SETTINGS>Bandwidth Mgt>Enable Bandwidth
Management) and then select PPPoE in BASIC
SETUP>WAN Settings>WAN1 IP>PPPoE as
your internet connection, it will show you a
message indicated as right column to tell you that
Bandwidth management will not support PPPoE
in this version. If you still like to use bandwidth
management, please try to use another method,
such as DHCP or Fixed IP, to connect Internet.
3.4.2 Setup DMZ1, LAN1 Status
Step 1 ¡ Ð
Setup DMZ port
Here we are going to configure the DMZ1
settings. Setup IP Address and IP Subnet
Mask, and determine if you would like to enable
the DHCP Server. If yes, please check Enable
DHCP Server. And then select None for Routing
Protocol. Click Apply to finish this setting.
FIELD
IP Address
IP Subnet Mask
Enable DHCP Server
IP Pool Starting Address
Pool Size
Primary DNS Server
Secondary DNS Server
Routing Protocol
BASIC SETUP > WAN Settings > WAN1 IP > PPPoE
BASIC SETUP > DMZ Settings > DMZ1 Status
DMZ port IP address
DMZ port IP subnet mask
Enable DMZ port of the DHCP Sever or not
Specify the starting address of the DHCP IP address.
Specify the numbers of the DHCP IP address.
Specify the Primary DNS Server IP address of the DHCP.
Specify the Secondary DNS Server IP address of the DHCP.
Determine to enable the dynamic routing protocol (RIP), to receive RIP
message, to send out RIP message if the message is received or not.
Table 3-2 Configure DMZ network settings
DESCRIPTION
17
DFL-900 User Manual
EXAMPLE
10.1.1.254
255.255.255.0
10.1.1.1
20
10.1.1.254
None
Advertisement
Table of Contents
