Table of Contents
Advertisement
D-Link
3.4.1 Setup WAN1 IP
Step 1 ¡ Ð
Setup WAN1 port
Here we select PPP over Ethernet method in
WAN1 port. Fill in the ISP-given User Name and
Password and the optional Service Name. And
then check the needed field. Click Apply to finish
this setting.
IP Address
Assignment
Service Name
User Name
Password
PPP over
Ethernet
Get DNS Automatically /
DNS IP Address
Disconnected
IP Address / Subnet Mask
Gateway IP
Fixed IP
DNS IP Address
Address
Routing Protocol
Get DNS Automatically or
Get IP
DNS IP Address
Automatically
(DHCP)
Routing Protocol
BASIC SETUP > WAN Settings > WAN1 IP > PPPoE
FIELD
ISP vendor (Optional)
The user name of PPPoE account
The password of PPPoE account
Get DNS Automatically
information from PPPoE ISP
DNS IP Address
and Secondary DNS Server information
Through click Connect or Disconnect button to connect
or disconnect PPPoE line
Specified IP address and subnet mask
Default gateway IP address
Specified Primary and Secondary DNS Server address
Determine to enable the dynamic routing protocol, to
receive RIP message, to send out the RIP message if
the RIP message is received or not.
Get DNS Automatically
information from DHCP Server
DNS IP Address
and Secondary DNS Server information
Determine to enable the dynamic routing protocol, to
receive RIP message, to send out the RIP message if
the RIP message is received or not.
Table 3-1 Detailed information of setup WAN port configuration
DESCRIPTION
Get DNS related
manually specify these Primary
Get DNS related
manually specify these Primary
16
Part I
EXAMPLE
12345678@hinet.net
G5468889
Get DNS
Automatically
Click Connect
211.43.123.7
255.255.255.0
211.43.123.254
None
Get DNS
Automatically
None
Advertisement
Table of Contents
