Viewing And Controlling Total Connect Scenes From Vam; Enabling Devices For Total Connect; Total Connect Server Screen For Troubleshooting - Honeywell VISTA User Manual

Viewing and Controlling Total Connect Scenes from VAM

Use the Scenes button to display and control scenes that have been created
in Total Connect.
1. From the Main menu, Click the Automation and Scene Setup buttons,
then Click the Remote button. The screen displays a list of scenes
created in Total Connect.
NOTES:
• The Local button allows you to view a list of scenes created in VAM.
• Scenes created in Total Connect can be edited only via Total Connect.
2. To control a Remote scene, select the desired scene, and then click the
appropriate action (ex. Run).

Enabling Devices for Total Connect

1. From the Main menu, click Setup > System > TC Server.
2. Click the TC Enable button; the "Z-Wave Device Management for Total
Connect" screen is displayed.
3. Select the device that you want to enable/disable in Total Connect.
NOTE: Devices are defaulted to Enable.
4. Click Save when done.
5. After devices have been enabled for Total Connect, follow the Total
Connect prompts to synchronize the data with VAM. Syncing is required
before the enabled devices will display in Total Connect.
NOTES:
1. Device IDs for Z-Wave devices could be different on VAM and Total
Connect web pages.
2. On Total Connect, the maximum number of supported devices is 40
switches, 3 thermostats, and 4 door locks.

Total Connect Server Screen for Troubleshooting

The TC Server screen displays the current server information and Z-Wave
device status. This information is typically used for IP connection
troubleshooting purposes in collaboration with a service technician.
Diagnostic Connect Clear TC Enable
– 28 –