Rack Mounting - Multitech FaxFinder FF440 Administrator's Manual

Chapter 2 – Hardware and Installation

Rack Mounting

When installing the unit in a closed or multi-unit enclosure, follow the recommended installation defined by
the enclosure manufacturer.
Note: The ambient temperature of the rack interior must not exceed 40° Celsius.
●
Do not place the unit directly on top of other equipment or place other equipment directly on top of the
unit.
●
If installing the unit in a closed or multi-unit enclosure, ensure adequate airflow within the rack so that the
maximum recommended ambient temperature (40° C) is not exceeded.
●
Ensure that the unit is properly connected to earth ground by verifying that it is reliably grounded when
mounted within a rack.
●
If a power strip is used, ensure that the power strip provides adequate grounding of the attached
apparatus.
●
When mounting the equipment in the rack, make sure mechanical loading is even to avoid a hazardous
condition. The rack should safely support the combined weight of all the equipment it supports.
●
Ensure that the main supply circuit is capable of handling the load of the equipment. See the power label
on the equipment for load requirements.
●
This equipment should only be installed by properly qualified service personnel. Only connect like circuits -
connect SELV (Secondary Extra Low Voltage) circuits to SELV circuits and TN (Telecommunications
Network) circuits to TN circuits.
19-Inch Rack Enclosure Mounting Procedure
16
Figure 6
Figure 7
FaxFinder x40 Administrator Guide