Table of Contents
Advertisement
7.3.5 Replacing the cleaning kit
Proceed as follows:
4.
Caution
The components in the fuser station reach a surface temperature of approximately
230
Before beginning work, open the fuser station and allow the printing system to cool
for approx.1/2 hour.
5.
248
o
C during operation. If you touch them, you may burn yourself.
Rotate the knob to the left until it
engages.
Take hold of the fuser station and pull
it towards you slowly and evenly.
Take hold of the cover plate by its
handle and lift it off.
A29246-X17-X-4-7680 / do701.fm
Advertisement
Table of Contents
