Table of Contents
Advertisement
Cleaning inside the fuser station
Proceed as follows:
Caution
The components in the fuser station reach a surface temperature of approximately
o
230
Cleaning should be done preferably before you power on the printing system, while
the fuser station is still cold. Alternatively, allow the fuser station to cool down for
approximately half an hour before you start work.
1.
2.
Important
Possibility of damage to the cleaning belt from the vacuum cleaner nozzle.
Do not vacuum-clean the cleaning belt.
A29246-X17-X-4-7680 / do601.fm
C during operation. If you touch them, you may burn yourself.
6.4.3 Cleaning the fuser station weekly
To clean the fuser station, take hold of
the cover plate by its handle and lift it
off.
Check for accumulations of oil in the
fuser station and clean. Traces of oil
on the paper impair the print quality.
Press the catches on both sides
towards the plate to release them.
Draw the cleaning unit up and out and
put to one side, with the cleaning belt
facing up.
191
Advertisement
Table of Contents
