DigiDesign D-Command Manual page 96

Press the encoder Select switch to move down and the By-
5
pass/Mute/Pre switch to move up through menu levels.
Press the encoder Select switch to confirm each menu level
6
selection.
Repeat steps 2–5 to modify other send or insert assignments.
7
Press the flashing encoder Select switch to confirm the as-
8
signment.
To remove an input, output, send or insert:
Press an Assign switch to enter the corresponding Assign
1
mode.
For the assignment you want to remove, press the encoder
2
Bypass/Mute/Pre switch repeatedly until you reach the top
level menu for the assignment.
Turn the encoder knob counter-clockwise until no assign-
3
ment is visible.
Do one of the following:
4
• Press the flashing encoder Select switch or press the flash-
ing Assign switch to confirm the removal.
– or –
• Press the flashing Escape switch to cancel the removal
and restore the assignment.
Assigning Inputs in Sessions with Multiple
Plug-In Outputs
In sessions with plug-ins that have multiple outputs, the out-
puts of those plug-ins are available as inputs in other audio
and Auxiliary Input tracks. These appear as a third category of
inputs, labelled plug-ins, in the track input menu.
When assigning inputs from D-Control, this third category of
inputs appears as a top-level menu choice.
To assign an input from a plug-in output:
Press the Assign Inputs switch.
1
On the channel where you want to make the assignment,
2
turn an encoder knob to select Plug-In from the first level of
menu choices.
Press the encoder Select switch to move down to the indi-
3
vidual plug-in level.
Turn the encoder knob to select the plug-in whose auxiliary
4
output you want to select.
Press the encoder Select switch to move down to the list of
5
plug-in auxiliary outputs.
90 D-Command Guide
Do one of the following:
6
• Press the flashing encoder Select switch or press the flash-
ing Assign Inputs switch to confirm the assignment.
– or –
• Press the flashing Escape switch to cancel the assign-
ment.
Making Elements Active or Inactive
You can make Inputs, Outputs, Inserts, Sends, and entire
tracks active or inactive directly from D-Command by enter-
ing a temporary Make Inactive mode.
To toggle input paths active/inactive:
Press the Make Inactive Inputs switch to enter the Make In-
1
active mode.
Press the Bypass/Mute/Pre switch on the appropriate en-
2
coder to deactivate or reactivate the input. Inactive inputs are
shown with an inverted text display.
Press the flashing Make Inactive switch to exit Inactive
3
mode.
To toggle output paths active/inactive:
Press the Make Inactive Outputs switch to enter the Make
1
Inactive mode.
Press the Bypass/Mute/Pre switch on the appropriate en-
2
coder to deactivate or reactivate the combined outputs for
that channel.
Press the flashing Make Inactive switch to exit Inactive
3
mode.
To toggle individual outputs sub-paths active/inactive:
Press the Make Inactive Outputs switch to enter the Make
1
Inactive mode.
Press the Select switch on the appropriate encoder to view
2
the output sub-paths for the channel.
Press the Page Up or Page Down switches to step through
3
the possible output sub-paths.
Press the Bypass/Mute/Pre switch on the appropriate en-
4
coder to deactivate or reactivate your choice of output
sub-paths. Inactive output sub-paths are shown with an in-
verted text display.
Press the flashing Make Inactive switch to exit Inactive
5
mode.
To toggle a send or plug-in active/inactive:
Press the Make Inactive Sends switch or the Make Inactive
1
Inserts switch to enter the corresponding Make Inactive
mode. The first two insert or send positions will show on the
encoder displays.