DigiDesign D-Command Manual page 61

Cycle Switch
The Cycle switch steps through all available Dynamics
plug-ins on the focused channel.
Master Bypass Switch
The Master Bypass switch bypasses the plug-in.
Page Switch
With plug-ins that have more than one page of controls, the
Page switch lights. Pressing this switch steps through the
pages for the currently displayed plug-in.
The current function of the rotary encoders in the Dynamics
section is shown by the corresponding indicator LEDs. Active
controls are shown in the on-screen plug-in window by col-
ored outlines.
Dynamics Gain Controls and Meters
Clip Indicator
Output meter
Gain Reduction meter
Level meters in the Dynamics section
Output Meter and Clip Indicator
The Output meter shows the output level for the current
plug-in. The Clip indicator lights when a clip is reported by
the plug-in, and can be cleared by pressing the Clear Clip
switch in the Session Management section.
Gain Reduction Meter
The Gain Reduction meter shows the amount of gain reduc-
tion for Compressor/Limiter functions (using the range
shown on the left) and Expander/Gate functions (using the
range shown on the right).
Chapter 7: Plug-in Controls 55