Chapter 3. Sync Peripheral Hardware And Software; Sync Peripheral Front Panel - DigiDesign SYNC HD Manual

chapter 3
SYNC Peripheral Hardware and Software

SYNC Peripheral Front Panel

Power Clock Reference
Switch
Clock Reference
LEDs
Figure 1. SYNC HD front panel
Controls and Displays
All SYNC peripheral local controls are on the
front panel. For information on back panel con-
nectors and setup, see Chapter 2, "Installation
and Configuration."
Power Switch
When the SYNC peripheral power switch is
pressed in, power is on; when the switch is out,
power is off.
The LED ring around the power switch is orange
while the SYNC peripheral is powering up, or
while firmware is being updated. The LED ring is
green when the SYNC peripheral is ready for
use.
Generator/Parameter
Controls
Loop
Time Code
Master
Display
Sample Rate
LEDs
Clock Reference Switch and LEDs
This switch selects the SYNC peripheral clock
reference, as indicated by the Clock Reference
LEDs. Available clock reference inputs include:
• Video Ref
• SYNC HD: (Green = SD, Yellow = HD)
• SYNC I/O: SD only
• Video In
• LTC (Linear Time Code)
• Digital
• SYNC HD: Word/AES
• SYNC I/O: Digital (Word or AES/EBU)
• Pilot
• Bi-phase/Tach
• Internal/VSO
• Loop Sync
Chapter 3: SYNC Peripheral Hardware and Software
Positional Reference Frame Rate
Switch
Switch
Drop Frame
Status LEDs
Positional LED
Frame
Reference
Rate
LEDs
LEDs
(Green = Word, Yellow = AES/EBU)
23