DigiDesign SYNC HD Manual page 68

Window Dub/Burn
By enabling this setting, you can superimpose a
window dub onto an incoming video signal.
The front panel lets you enable window dub but
does not let you adjust any window options.
To enable or disable the SYNC peripheral window
dub from the front panel:
Select Burn Enabled ("burn EnA"), using the
1
Set, Down, and Up switch.
Press Set.
2
Use the Down and Up switches to toggle be-
3
tween On/Off.
Press Set. The SYNC peripheral will retain the
4
setting, even when the unit is powered off and
on again, until it is changed.
See "Generating a Window Dub" on page 56 for
Pro Tools and the SYNC Setup software utility
window dub instructions. See "SYNC Peripheral
Defaults" on page 68 for default display settings.
Freewheel Length/Duration
Freewheel Length sets the period of time for
which the SYNC peripheral will continue to re-
generate time code when incoming time code is
interrupted.
See "Freewheel Duration" on page 44 for an ex-
planation of this feature.
62 SYNC HD Guide
To set the freewheel duration:
Select Freewheel Length ("FrEE LEn"), using
1
the Set, Down, and Up switches.
Press Set. The LED Time Code Display displays
2
the current setting, in frames.
Use the Down and Up switches to scroll pa-
3
rameter values.
Press Set.
4
LTC Output Level/Gain
Adjusts the audio level of the SYNC peripheral
LTC output, from –24 dBu to +9 dBu.
The SYNC HD shows the following:
The SYNC I/O shows the following:
See "Adjusting LTC Output Level/Gain" on
page 40 for step-by-step LTC level instructions.
To set the LTC output level:
Select LTC Level/Gain ("L7C LEUL" on
1
SYNC HD, or "L7C GAIn" on SYNC I/O), using
the Set, Down, and Up switches.
Press the Set switch again. The LED Time Code
2
Display shows the current setting, in dBu.
Use the Down and Up switches to scroll pa-
3
rameter values.
Press Set.
4