DigiDesign SYNC HD Manual page 66

SYNC peripheral front panel display of parameters
LED
SE7 6En
dI6 rEF
SPL FrEC
PuLL r7E 1
PuLL r7E4
bASE CLOC
VI7C InS
rdr LInE
6En LInE
burn EnA
FrEE LEn
L7C LEUL/GAIn
SErVo Gn
PICH HLd
bIPH PPF
bIPH SI6
VIdEO SY
Hd VIdEo
IdLE 7C
dEvicE id
USd CPA7
60 SYNC HD Guide
Parameter
Set Generator Start Time
Digital Reference
Sample Freq (Rate)
Pull Up/Down 0.1%
Pull Up 4.167%, Down 4.0%
External Clock Out
VITC Insertion
(VITC) Reader Line
(VITC) Generate Line
Window Burn On/Off
Freewheel Duration
LTC Output level/gain
LTC Servo gain
Pitch Hold On/Off
Bi-Phase Pulse-per-frame
Bi-Phase Signal Configuration
Video Format (NTSC/PAL)
HD Video Format (SYNC HD only)
Idle MTC On/Off
Device ID (SYNC HD only)
USD Compatibility mode On/Off
(SYNC I/O only)
Set Generator Start Time
Lets you set a start time for the SYNC peripheral
time code generator.
See "Generator Start Time" on page 51.
Digital Clock Reference
The SYNC peripheral can use AES/EBU or Word
Clock (1x) for digital clock reference.
See "Digital Clock (AES/EBU or Word Clock) Op-
tions" on page 38.
Sample Rate
Selects the SYNC peripheral sample rate.
See "Sample Rate" on page 17.
Pull Rate
Two Pull Rate settings enable 0.1%, and 4%, Pull
Up or Pull Down for the current sample rate.
Pull Rate1 Lets you enable 0.1% pull up or
down.
Pull Rate4 Lets you enable 4.167% pull up, or
4.0% pull down, when available.