DigiDesign SYNC HD Manual page 70

Bi-Phase/Tach Pulses Per Frame
Bi-Phase/Tach involve several settings, includ-
ing pulse per frame. This sets the number of Bi-
Phase/Tach pulses per frame of time code.
To set the pulses per frame value for a
Bi-Phase/Tach signal:
Select Bi-Phase/Tach Pulses Per Frame
1
("bIPH PPF"), using the Set, Down, and Up
switches.
Press Set.
2
Use the Down and Up switches to scroll pa-
3
rameter values.
Press Set. The SYNC peripheral retains the set-
4
ting, even when the unit is powered off and on
again, until it is changed.
Bi-Phase/Tach Input Signal
In addition to other Bi-Phase/Tach parameters,
the Input Signal defines the direction of the Bi-
Phase/Tach signal.
For complete instructions, see "Bi-Phase/Tach
Signal" on page 47.
64 SYNC HD Guide
Video Format/System
Selects the format (NTSC or PAL) for both the in-
coming and outgoing video signals.
NTSC The standard for North and South Amer-
ica, Japan, and certain other parts of the world
PAL Used in most of Europe, Asia, and Africa.
Users of SECAM video (for France, Russia, and
other parts of the world) should select PAL.
Be sure you have selected the correct video
format. The SYNC peripheral will not warn
you if you have chosen the wrong one.
To select a video system:
Select Video System ("VIdEo SY"), using the
1
Set, Down, and Up switches.
Press Set.
2
Use the Down and Up switches to toggle the
3
parameters between the following:
• NTSC ("n75C")
• PAL ("PAL")
Press Set. The SYNC peripheral will retain the
4
setting, even when the unit is powered off and
on again, until it is changed.