DigiDesign SYNC HD Manual page 67

Base Clock
Configures the Word Clock Out port. Choices
are Session (1x the base session sample rate), or
256x (for Slave Clock devices).
The base sample rate is 44.1 kHz when ses-
sion sample rate is 44.1, 88.2, or
176.4 kHz, or 48 kHz when session sample
rate is 48, 96, or 192 kHz.
VITC Insertion
When selected, VITC will be inserted onto the
outgoing video signal—assuming that a video
signal is present at one of the SYNC peripheral
video inputs, and that the SYNC peripheral is in
a valid mode for inserting VITC.
To configure the SYNC peripheral to insert VITC
using the front panel:
Select VITC Insertion ("VI7C InS") using the
1
Set, Down, and Up switches.
Press Set.
2
Use the Down and Up switches to toggle be-
3
tween On/Off.
Press Set.
4
VITC Read Lines
This setting determines which line pair of in-
coming video is used for the VITC source.
To choose the VITC read lines:
Select VITC Read Lines ("rdr LInE"), using the
1
Set, Down, and Up switches.
Press Set.
2
Use Down and Up to scroll parameters, which
3
include:
• Auto (ALL-LInE)—where the SYNC periph-
eral will search all lines and select the first
valid line pair automatically
• A currently selected read line pair.
Press Set.
4
VITC Generate Lines
This setting determines the line pair of the video
signal at the Video Out connector onto which
the SYNC peripheral inserts VITC. Normally,
this should be left at the default setting of 14/16.
To choose the VITC generate lines:
Select VITC Generate Lines ("6En LInE"), us-
1
ing the Set, Down, and Up switches.
Press Set. The LED Time Code Display displays
2
the current lines.
Use the Down and Up switches to scroll pa-
3
rameter values.
Press Set. The SYNC peripheral will retain the
4
setting, even when the unit is powered off and
on again, until it is changed.
Chapter 5: Additional Operational Information 61