DigiDesign SYNC HD Manual page 22

When the SYNC peripheral is not the selected
Clock Source device, the Clock Reference menu
in the SYNC Setup section switches to Loop
Sync.
For LTC clock reference, multiple choices
are available from the LTC sub-menu. See
"LTC and Clock Reference" on page 39.
To choose a Clock Reference:
Select an available clock source from the
Clock Reference pop-up menu in the Session
Setup window.
Choosing a Clock Reference
The Clock Source pop-up menu follows your se-
lection of the SYNC peripheral for Clock Refer-
ence by automatically switching to the SYNC
setting. (You can also choose the SYNC periph-
eral as Clock Source first, then select a Clock Ref-
erence.)
16 SYNC HD Guide
To choose a different Loop Sync device as the
Clock Source:
Select a different Loop Sync device and Clock
Source from the Clock Source pop-up menu in
the Session Setup window.
Choosing a Clock Source (96 I/O shown)
When Clock Source is an HD I/O
When a 192 I/O, 192 Digital I/O, 96 I/O or
96i I/O is providing the Clock Source, it will be
the Loop Master. Clock Source options are avail-
able directly from the Clock Source menu, based
on the configuration of that interface in the
Hardware Setup dialog. Choices can include
AES, S/PDIF, Optical, or Word Clock.
See the HD Setup Guide for more information
on configuring audio interfaces.