Paper Loading Procedure (Rear) - TransAct Printrex 980 Operator's Manual

Step-by-Step Installation Instructions

Paper Loading Procedure (Rear)

This section describes the method for loading the paper to be fed from the rear
of printer.
1. Make sure that the Power key lamp on the operation lamp stays lit.
If the printer has been turned off completely, turn on the power switch. When
the printer is in the sleep mode, press the Power key.
2. Open the ink tank door.
Note: If there is paper in the paper tray, remove it and then move the paper
tray down.
3 Push the upper unit release lever up to open the upper unit.
Page 48 100-11672 - Rev D