Initial Check Items; Checking The Installation Environment; Checking The Paper; Checking Settings - TransAct Printrex 980 Operator's Manual

Appendix A: Ordering Genuine Ithaca Supplies

Initial Check Items

Checking the Installation Environment

Check whether the installation place meets the following requirements:
1) The power supply voltage must be the rated voltage from -15% to +10%
and the power supply frequency must be the rated frequency ±2Hz.
2) The printer must be held horizontal.
3) The ambient temperature must be held at 15-30 degrees and the humidity
at 10-80%.
4) Avoid the place where both the temperature and humidity are high (near the
faucet, boiler, or humidifier), the temperature is extremely low, the temperature
changes greatly. Also avoid placement near fire or flame.
5) Avoid dusty locations.
6) Avoid the place exposed to direct sunlight. If it is inevitable to install the
printer in such a place, instruct the customer to hang curtains.
7) The room must be well-ventilated.

Checking the Paper

1) Check whether dedicated paper is used.
2) Check whether the paper is moist. Unpack new paper, load it in the printer,
and check for printing.
3) Check whether the paper is curled.

Checking Settings

Check whether the settings made for the printer are suitable for the paper
used and other requirements, specifically, in terms of the following:
1) Paper setting
Paper size (height and width)
2) Printing condition
Number of prints
3) Interface setting
USB 2.0 High Speed Function (1ch)
Giga Bit Ether Net
4) Saving of set conditions
Check whether settings have been saved properly.
100-11672 - Rev D Page 113