Adjustment; Adjustment When Replacing Parts - TransAct Printrex 980 Operator's Manual

Adjustment

Adjustment When Replacing Parts

This section describes the works to be carried out, as an after-sale service,
after parts replacement.
Target Parts Adjustment Item
Print Module Print Modules in
place
Input of various
adjustment values
(*1) (Indicated on
labels)
Head position (*2)
Printhead Head position (*2)
Purge Unit Blade position
Input of Purge Unit
wipe position
(Indicated on label)
Transport Unit Pinch Roller position
Head position (*2)
Backfeed gap
Rack Unit Rack position
Lift Unit / Rear Rear Feeder sensor
Feeder sensor
Stacker Rail / Front Tray Unit
Front Tray
Unit
Printer In the case data can
Controller be retrieved (Send
PCB the data to Printer )
In the case data can
be retrieved (serial
number, time, various
adjustment values
(*1), Rear Feeder
Sensor, ink eject
power, Printhead
position, backfeed
gap)
DC Power Ink eject power
Supply PCB
(*1) Printhead wipe position, Printhead capping position, Printhead print
position, and Purge Unit wipe position
(*2) T-K gap, slant, and Head position
(*3) Use adjustment tool (supplied with service parts).
Appendix A: Ordering Genuine Ithaca Supplies
Reference section in manual
"Work at Print Module Replacement"
"Print Module Replacement Procedure"
"Head Position Adjustment"
"Head Position Adjustment"
"Blade Position Adjustment"
"Consumable Parts Replacement
Procedure"
"Pinch Roller Position Adjustment"
"Head Position Adjustment"
"Backfeed Gap Adjustment"
"Work at Rack Unit Replacement"
"Rear Feeder Sensor Adjustment"
"Work at Stacker Rail and/or Front Tray
Unit Replacement"
"• In the case data can be retrieved from
Printer Controller PCB to PC."
"• In the case data cannot be retrieved
from Printer Controller PCB to PC."
"DC Power Supply Unit Replacement
Procedure"
100-11672 - Rev D Page 137