Step 4: Loading Ink Cartridges And Paper - TransAct BANKjet 1500 Operator's Manual

2 2 2 2

Step 4: Loading Ink Cartridges and Paper

' $ % ' $ % ' $ % ' $ %
)( :' + )( :' + )( :' + )( :' + 0 0
9 9 E E
9 9 E E
$ $ $ 9 $ 9
$ $ $ 9 $ 9
Use the * Button to set the printer into OPERATIONAL/ON mode before you install the ink cartridges. Confirm that
the printer is in this mode by checking that the
Caution: Do not touch the ink cartridge's metallic connector surface with your fingers. Doing so will contaminate
the connector and produce sub-standard print quality.
1. Remove the new ink cartridge(s) from their sealed pouch and remove the Mylar tape from the face of the new
ink cartridge. (Holding the cartridge by the tab will ensure a clean installation.)
2. Press the OPEN COVER Buttton to release the rear paper cover from the console, then swing the rear paper
cover towards the back of the printer. (Opening the printer's front cover will also open the rear paper cover.)
NOTE: If paper is present, ensure that the receipt is torn off prior to opening the front cover.
Revision E
E E E E 9 9 9 9
0 0 9 9 9 9 0 0 0 0
3 3
3 3
. + ( " $ $ ) " < $ )
C D C D C D C D 5 % 5 % 5 % 5 %
% % % % % % % % E E E E
is activated.
0 0 0 0 3 3 3 3
* * * * * * * *
:
* * * *