Connect A Lan Cable; Switching The Printer On And Off; Switching The Printer On - TransAct Printrex 980 Operator's Manual

Step-by-Step Installation Instructions
Note: Whenever connecting a USB cable to the printer, put the USB cable in
the cable clamps as shown in the figure.

Connect a LAN cable

Connect the LAN cable to the printer, as shown in the figure, and then the
computer.
Note: Please consult your network administrator when connecting to an office
LAN.
Note: If a printer driver has not been installed in the computer to which you
want to connect your printer, install it before connecting the USB cable or LAN
cable.

Switching the Printer On and Off

Switching the Printer On

1. Turn on the power switch.
When the [STATUS] lamp which has been blinking stays lit, the printer is
ready for printing.
100-11672 - Rev D Page 37