Current Satellite List; Addressing A Satellite Position; Deleting Satellite Position; Reference Position - TechniSat DigitMod S1 Operating Manual

9.4 Current satellite list

The satellite positions saved are included in the satellite list.
Positions not yet saved are marked in the list with a "*".
> To turn the dish to a position included in the satellite list, use
the arrow keys to mark the field Current satellite list.
> Confirm by pressing OK.
> Use the arrow keys up/down to select the desired
position.
> Confirm by pressing OK.
The dish will now be turned to the position selected. The
rotating procedure will be indicated by the blinking display
"turn" in the menu.

9.4.1 Addressing a satellite position

To turn the antenna to the position set in your satellite list, your
digital receiver is equipped with the function turn to sat.
> Press the yellow function key Actions to open the window
showing the available actions.
> Now use the arrow keys up/down to mark the line turn
to sat.
> Confirm by pressing OK.
> Press the green function key (turn to sat) to turn the
antenna to the satellite position selected.
9.5 Deleting a satellite position
To delete a satellite position from the satellite list, proceed as follows:
> Use the arrow keys to mark the field Current satellite
list.
> Press OK to open the current satellite list.
> Use the arrow keys up/down to select the satellite you
wish to delete.
> Confirm by pressing OK.
> Use the arrow keys to mark Delete sat.
> To delete the satellite press OK and confirm the message
displayed by pressing OK again.

9.6 Reference position

When installing the external installation, the motor must be in the
reference position (0°). You can thus return the motor to this position
(0°) at any time using the function "Go to reference position".
> Press the red function key Ref.pos to turn the antenna
automatically to its reference position.
55