Table of Contents
Advertisement
(Fig. 7-1)
If the current time is not displayed, this must still be acquired
by the receiver. To do this, switch the unit on, and set it to
receive a major channel such as ZDF for about 30 seconds,
during which time the clock setting will be automatically
acquired.
7.2 Selecting a programme
7.2.1 Using the Programme up/down keys
>
You may use the programme keys up/down either on
the receiver or on the remote control to switch up or down
one programme slot at a time.
7.2.2 Using the numeric keys
>
You may use the numeric keys to enter the desired pro-
gramme number.
For example:
1
1,
then 4
2,
then 3,
then 4
When entering prtogramme numbers consisting of several digits, you
have approximately 3 seconds after pressing a key to complete the
entry.
If you wish to enter a programme number consisting of only one or
two digits, you can speed up the switching procedure by holding
down the key on the last digit a little longer.
7.2.3 Using the Navigator (Programme list)
>
Press OK.
The programme list navigator will be displayed. In TV mode,
only TV programmes will be shown, and only radio program-
mes when in Radio mode. The programme currently selected
is marked. (Fig. 7-1)
>
Now use the arrow keys up/down to mark the desired
programme.
>
Press the OK key to display the marked programme.
>
Use the arrow keys up/down to move the market in the
list by one line at a time.
>
Use the arrow keys left/right to move back and forth in
the list one page at a time.
7.2.3.1 Selecting a list
You receiver is equipped with several programme lists, designed to
make it easier for you to find a programme. You may select your
Favourites list (see Point 8.1), or view the alphabetically sorted
20
for programme slot 1
for programme slot 14
for programme slot 234
Advertisement
Table of Contents
Need help?
Do you have a question about the DigitMod S1 and is the answer not in the manual?