TechniSat DigitMod S1 Operating Manual page 13

Position A/Option A
> Use the arrow keys up/down to mark the satellite
you wish to receive at the DiSEqC setting Position
A/Option A and confirm by pressing OK. (Fig. 5-7)
Position B/Option A
> Use the arrow keys up/down to mark the satellite
you wish to receive at the DiSEqC setting Position
B/Option A and confirm by pressing OK. (Fig. 5-8)
Position A/Option B
> Use the arrow keys up/down to mark the satellite
you wish to receive at the DiSEqC setting Position
A/Option B and confirm by pressing OK. (Fig. 5-9)
Position B/Option B
> Use the arrow keys up/down to mark the satellite
you wish to receive at the DiSEqC setting Position
B/Option B and confirm by pressing OK. (Fig. 5-10)
In the next step, you should check on the correct configura-
tion of your antenna.
> If you wish to accept the settings entered, use the
arrow keys up/down to mark the field Yes, and
confirm by pressing OK. (Fig. 5-11)
Updating Software
When you have completed the antenna settings, the digital
receiver will check whether a new version of the operating
software is available via satellite. In case new software is
available, you can perform an automatic software update.
> Use the arrow keys left/right to select the field
Update, and confirm by pressing OK.
(Fig. 5-12) The new software for your unit will now be
downloaded. This procedure may take several minutes.
13
(Fig. 5-8)
(Fig. 5-9)
(Fig. 5-10)
(Fig. 5-11)
(Fig. 5-12)