Copying Settings; System Configuration - TechniSat DigitMod S1 Operating Manual

(Fig. 8-31)
(Fig. 8-32)
> In the line Update time use the numeric keys to enter
the time at which the software update is to be carried out.
> To start the update of the operating software manually, press
the red function key Test.
> Press the Menu key to return to normal operation.
Should the parameters of the data channel for downloading the soft-
ware updates have changed, you can correct these manually in this
menu, as described under Point 8.3.4 (manual programme
scan).Current transponder data can be obtained from your specialist
retailer. In general you should not make any changes in this menu.
Note:
The new software can be downloaded automatically
only when the digital receiver is in stand-by mode. The
downloading procedure is indicated by alternating flas-
hing of the display LED´s. Do not interrupt this procedu-
re by switching the receiver on or off.
Independently of whether you have switched the automatic software
updating function on or off, the system will automatically check for the
availability of a new operating software version for your digital receiver
each time you switch on the receiver. If a new version is available, a
corresponding message will be displayed on screen (Fig. 8-31).
To start the software update, follow the instructions displayed on
screen.
8.5.5 Copying the settings
You have the facility to copy all the settings, such as programme list,
antenna settings, etc. of your digital receiver (sender) to another digi-
tal receiver (receiver) of the same type, and using the same version
of the operating software. (Fig. 8-32)
> To do this, connect the two receivers by means of a null
modem cable.
> Switch on the (destination, receiving) receiver.
> To copy the settings, press any operating key on the (source,
sending) receiver.
The settings of the source receiver will now by transmitted to
the destination receiver. Please note any messages display-
ed on screen.

8.6 System configuration

Use this menu item to view the specific receiver data (e.g. current
software version).
> Use the arrow keys up/down to mark this line in the sub-
menu Settings.
> Confirm by pressing OK.
> Press the Menu key to return to normal operation.
48