Sfi Timer Programming; Sfi Programme Overview - TechniSat DigitMod S1 Operating Manual

the arrow keys.
> Press the Back key to return to the previous table.

7.14.7.2 SFI timer programming

The electronic programme guide SFI allows you to programme timer
events with particular ease.
> Use the arrow keys or the function keys to mark the
desired programme.
> Press the red function key Timer to open a selection win-
dow.
> Use the arrow keys up/down to mark the required
Timer type (see Point 7.16.1.2).
> Confirm by pressing OK. The menu Manage timer sho-
wing the data relating to the programme selected will be
displayed, so that you can check on the correctness. If requi-
red, you can make changes in this menu (see 7.16).
> Press the Back key to return to the previous table.
The relevant line is marked. Depending on the timer type in
use, the receiver will now be switched on at the commence-
ment of the selected programme. If the receiver was swit-
ched on by means of the video recorder timer, this will be
indicated by the message "rEc" shown in the display.Most of
the functions of the remote control are disabled at this stage,
to avoid accidental interruption of the recording.
In stand-by mode, an active timer is indicated by the colon in
the time display blinking, or by the LED.
Deleting a SFI timer event
> If you would like to cancel a timer event programmed via the
SFI, proceed as described above, to mark the appropriate
programme.
> Press the red function key Timer to open a selection win-
dow.
> Use the arrow keys up/down to mark the line Delete
Timer.
> Confirm by pressing OK.
> To abort an active timer, switch of the digital receiver using
the On/Standby key.
> Press the same key again to switch the receiver on again,
and full functionality will be restored.

7.14.7.3 SFI programme overview

Use the SFI programme overview to display a table with the day's
programmes of a single channel. To do this, proceed as follows:
> Press the SFI key.
The SFI table "Now" will be displayed.
28