Table of Contents
Advertisement
Installing the USB Drivers for FRITZ!Box Fon WLAN in Mac OS X
36
FRITZ!Box Fon WLAN 7050 – 2 Starting FRITZ!Box Fon WLAN 7050 Operation
Installing the USB Drivers for FRITZ!Box Fon
WLAN in Mac OS X
1.
Select "System Preferences / Network". You receive the
message that a new port, "Ethernet port en<No.>", was
found. Confirm the message by clicking "OK".
2.
Under "Show", select the new port found, "Ethernet
port en<No.>".
3.
Confirm your entries with "Activate Now".
4.
Please see the instructions in the section "Opening the
User Interface" on page 37.
Installing the USB Drivers for FRITZ!Box Fon
WLAN in a Linux Operating System
The example of SUSE Linux 9.0 is used here to describe how
to install FRITZ!Box Fon WLAN to the USB port in Linux.
1.
Open the YaST Control Center.
2.
Select the option "Network Devices" and click "Network
Card".
3.
The "Network cards configuration" dialog appears.
4.
Select "Other (not detected)" and the "Configure..."
button.
5.
The device type of the network in the "Manual network
card configuration" window should be set to "Ether-
net". Select the "USB" check box as well and click
"Next".
6.
In the input mask "DSL Configuration", the PPP mode
should be set to "Ethernet", for "Network cards to con-
figure" select "Other (not detected)". Click the "Config-
ure..." button.
7.
In the next dialog, "Network address setup", select the
"Automatic address setup (via DHCP)" option. Click
"Next".
8.
Changes to the configuration take effect when the
"Finish" button is clicked.
Advertisement
Table of Contents
