AVM Fritz!Box Fon WLAN 7050 Installation, Configuration And Operation page 109

Dsl/wlan

Table of Contents

To suspend a call, proceed as follows:

You will hear an acknowledgement tone to indicate that the

call has been successfully suspended. If you hear the failure

tone, this may indicate that you made a mistake, or that the

Suspend/Resume feature is not enabled on your line. It is al-

so possible that the parked-call ID you chose is already in

use.

To resume the connection, proceed as follows:

Call Tracing (MCID)

During a call or after the caller hangs up, dial the following

sequence:

Rs39r

For more information about this feature, contact your ISDN

provider.

FRITZ!Box Fon WLAN 7050 – 10 Configuration and Operation by Telephone 109

You are talking to Caller 1.

Press the Hold button. Call 1 is now suspended.

Dial the sequence shown at left. Type in the

parked-call ID as "PC". The parked-call ID can be

any number between 0 and 99. You will need to

enter this ID again when you resume the call.

After the acknowledgement tone, the connection

is suspended. You can hang up the handset. The

call remains suspended at the ISDN provider's lo-

cal switch for two minutes.

Pick up the handset again. (You may not have a

call on hold. Otherwise, FRITZ!Box Fon WLAN will

attempt to suspend it.)

Dial the sequence shown at left. Type in the

parked-call ID as "PC". The parked-call ID is the

number you entered when you suspended the

call.

Dial the sequence shown at left.

Call Tracing (MCID)

Table of Contents