Table of Contents
Advertisement
After changing data, most changes are made immediately without restarting the
system. Changes that require one or more components to be restarted are noted in
Appendix C"Appendix C - component-specific system attributes" on page 223.
Note: You should not change any of these values unless you are very familiar with
the way the WebSphere Partner Gateway product operates. Typically system
configuration data is changed only by experienced systems or support engineers. If
you do change this data, record the original value or values so you can revert to
your original values if it becomes necessary.
Configuring the alert mail server
Alerts are text-based e-mail messages notifying partners of a system event. If you
are going to use these alerts, configure the SMTP server along with the reply-to
e-mail addresses. You must configure the reply-to e-mail addresses in the event
there are delivery difficulties.
To locate the configuration attributes, navigate to System Administration >
DocMgr Administration > Alert Engine within the WebSphere Partner Gateway
console.
The attributes are:
v bcg.alertNotifications.mailHost
v bcg.alertNotifications.mailFrom
v bcg.alertNotifications.mailReplyTo
v bcg.alertNotifications.mailEnvelopeFrom
Additional descriptions regarding the purpose and values for these attributes are
located in Table 58 on page 237.
Viewing system activity
About this task
WebSphere Partner Gateway periodically summarizes data about system activity.
This summary-service data is the information you see when you use the Document
Analysis or Document Volume Report functions.
Use the Summary Service Properties window to edit how often the data is
generated. This window also displays the date and time that the summary data
was last updated.
To change the time interval, follow these steps:
1. Click System Administration > DocMgr Administration > Others >Summary
2. On the Summary Service Properties window, click the Edit icon next to
3. Type a value (from 1 through 60), indicating the number of minutes before data
4. Click Save.
Engine.
Processing Interval (in Minutes).
is summarized again. The default value is 15.
Chapter 4. Hub administration tasks
33
Advertisement
Table of Contents
