Table of Contents
Advertisement
3. Scroll down until you see the Troubleshooting heading near the bottom of the
page. Click Logging and Tracing under Troubleshooting.
4. Click Diagnostic trace to view the details of the tracing configuration.
By default, trace files for the distributed mode of WebSphere Partner Gateway
applications are configured as shown in Table 40. The trace files are written in
<WebSphere Partner Gateway install dir>/wasND/profiles/<profile-name>/logs/
<server-name> directory. This is the same place that the log files are written by
default.
Table 40. Distributed mode trace configuration
Application
Receiver
Document manager
Console
Messaging server
The installer sets the logging level for all components of the WebSphere Partner
Gateway applications to log severe level trace messages. The logging level controls
the amount of tracing information that is provided by components. To change the
logging levels, see "Setting log detail levels" on page 144.
Tracing tasks common to both types of systems
About this task
1. Locate the server in the console by clicking on Servers/Application servers in
the left pane to list the server names in the right pane.
2. View the details of the server that you want to configure by selecting the server
name in the list.
3. Scroll down until you see the Troubleshooting heading near the bottom of the
page. Click Logging and Tracing under Troubleshooting.
4. Click JVM logs to see the details of the logging configuration. The window has
two pages: Configuration and Runtime.
Note:
a. Changes made on the configuration page take effect after the server is
restarted. These changes persist across server restarts.
b. Changes made on the runtime page take effect immediately but do not
persist across server restarts unless Save runtime changes to configuration
is selected.
5. The Configuration and Runtime pages both contain a link on the right side
called Change Log Detail Levels. This is where you can:
v Enable WebSphere Partner Gateway components to write to the trace file
v Select the logging level for each enabled component. The logging level
controls the amount of tracing information that is provided by components.
To set the log detail levels, see "Setting log detail levels" on page 144.
Key features that you should understand on the Configuration page are:
v The tracing is not written to the file named until you select Enable Log , save
the change, and restart the server.
Trace file name
Format
Advanced
bcg_receiver.log
Advanced
bcg_router.log
Advanced
bcg_console.log
Basic
trace.log
Chapter 14. Using logging and tracing features
Number
Maximum
of files
file size
10
10 Mb
10
50 Mb
10
50 Mb
1
20 Mb
143
Advertisement
Table of Contents
