Replacing Van Seat Armrest Pad Assembly - Invacare Pronto M91 Service Manual

SECTION 5—ARMS

Replacing Van Seat Armrest Pad Assembly

NOTE: For this procedure, refer to FIGURE 5.3.
1. If necessary, remove the joystick. Refer to Disconnecting/Connecting the Joystick on
page 92.
2. Remove the mounting screw, washers and locknut that secure the existing armrest pad
assembly to the arm post.
3. Position the new armrest pad assembly on the armrest post and secure with the
mounting screw, washers, and locknut. Refer to FIGURE 5.3 for correct hardware
orientation.
4. If necessary, install the joystick. Refer to Disconnecting/Connecting the Joystick on
page 92.
5. Repeat STEPS 2-4 for the opposite armrest plate, if necessary.
Mounting Screw
Washers
FIGURE 5.3 Replacing Van Seat Armrest Pad Assembly
® ™
Pronto M91 and M94
Washer
52
Armrest Pad
Assembly
Arm Post
Locknut
Part No. 1125038