Figure 3-2. Entering Dlt Or 9840 Cartridges Through The Cartridge Access Port - HP Surestore Tape Library Model 10/588 Hardware Manual

Operating in Automated Mode
CAUTION:
Do not slam the CAP. Cartridges could become unseated and be
extended out into the path of the robotics, causing severe damage to the
robot hand.
4. Close the CAP. The lock automatically engages.
Note: The LSM management software determines what happens when you

Figure 3-2. Entering DLT or 9840 Cartridges through the Cartridge Access Port

3-4
enter a cartridge upside down or with an unreadable label. Under
normal conditions, the camera on the hand audits the CAP and
recognizes that a cartridge is present, but the hand does not move it.
You must remove the cartridge from the CAP. With some host software,
the LSM might stop operating. With other host software, you are
prompted to type a label number when no VOLSER is read. If you do
type a label number, you might cause a problem later during an audit,
because the camera still will not be able to read an unreadable VOLSER
on the cartridge.