Setting Cleaning Cartridge Count - HP Surestore Tape Library Model 10/588 Hardware Manual

Library storage module

Hide thumbs Also See for Surestore Tape Library Model 10/588:

Table of Contents

Setting Cleaning Cartridge Count

Drives might occasionally need to be cleaned to prevent read/write errors. The

drives are cleaned with a special cleaning cartridge. After a specified number of

uses, the cartridge must be replaced.

If your LSM was configured during installation to have the AUTO CLEAN feature

enabled, you can use the LSM operator panel to set the maximum number of

times a cartridge can be used. You can use the View Config section of

Figure 2-4 in Chapter 2 to determine whether the feature is enabled. The DLT

Tape Drive Product Manual suggest that you use a DLT cleaning cartridge about

20 times. For 9840 linear serpentine cartridges, refer to the 9840 Tape Drive

User's Reference Manual PN 95739.

Refer to

Figure 2-2

and

Figure 2-4

to set the count.

2-7

Table of Contents

Do you have a question about the Surestore Tape Library Model 10/588 and is the answer not in the manual?

A4845a