Operating The Lsm; Powering On Or Ipling The Lsm - HP Surestore Tape Library Model 10/588 Hardware Manual

Library storage module

Hide thumbs Also See for Surestore Tape Library Model 10/588:

Table of Contents

Operating the LSM

This chapter contains the procedures for:

• Powering on the LSM

• Powering off the LSM

• IPLing the LSM

• Operating in automated mode

• Operating in manual mode

Note: When the LSM is controlled by the host, refer to your software

CAUTION:

To prevent damage to the drive, make sure that each drive is empty and

each DLT handle is up. On DLT4000 model drives, you can see whether

the handle is down. On DLT7000 model drives, look for the white hub. If

the hub is up, the handle is down.

positions.

If the handle is down and the Operate Handle indicator is on, push the

shuttle all the way back, pause, then release. The handle will rise. If the

indicator is not on, contact your customer engineer for assistance.

The above caution does not apply to the 9840 tape drives. The 9840

drives do not have a handle.

To power on the LSM, lift the power switch on the bottom right corner of the

right front door of the LSM.

To IPL the LSM, press the IPL softkey on the LSM operator panel.

publications and enter the command using the LSM management

software to perform the desired activity. For some activities, you might

have to ask your systems administrator for the required information

Figure 3-1

shows the handle

3-1

Table of Contents

Do you have a question about the Surestore Tape Library Model 10/588 and is the answer not in the manual?

A4845a