Download  Print this page

Setting The Scsi-2 Address - HP Model 705 - Workstation User Manual

Hp dds-2 tape drive user's guide (a1658-90701)
Hide thumbs


Setting the SCSI-2 Address

The DDS-2 drive must have a unique SCSI-2 target address. The DDS-2 drive's jumpers
are set at the factory to the SCSI-2 default address of 3 as shown in Figure 1–3. You must
also ensure that the Operation Mode jumpers are set for correct drive operation, as shown
in Figure 1–4. We ship the drive with the Operation Mode jumpers set to operate
correctly with your system. We recommend that you keep the default address, if possible.
CAUTION: SCSI tape drives are susceptible to mechanical and electrostatic
shock. When handling a DDS-2 drive, always wear the static-
grounding wrist strap that comes in the DDS-2 drive kit, and al-
ways handle the drive carefully.
Electrostatic charges can damage drives. To prevent such damage
from occurring, observe the following precautions during unpack-
ing and installation:
If you need to change the DDS-2 drive's address or operation mode, follow these
instructions, referring to Figures 1–3 and 1–4.
Locate the jumpers at the back of the DDS-2 drive.
To change the jumper settings, use needlenose pliers to set the drive's SCSI ID to an
address that is not used by another SCSI device. Check that the other jumpers are set
Stand on a static-free mat.
Wear a static strap to ensure that any accumulated electrostatic
charge discharges from your body to ground.
Connect all equipment together, including the static-free mat,
static strap, routing nodes, and peripheral units.
Keep uninstalled DDS-2 drives in their protective antistatic


Table of Contents

  Also See for HP Model 705 - Workstation

  Related Manuals for HP Model 705 - Workstation