Setting The Scsi-2 Address - HP Model 705 - Workstation User Manual

Setting the SCSI-2 Address

The DDS-DC drive must have a unique SCSI-2 target address. The DDS-DC drive
jumpers are set at the factory to the SCSI-2 default address of 3, as shown in Figure 1–3.
We recommend that you keep the default address, if possible.
You must also ensure that the Operation Mode jumpers are set for correct drive operation,
as shown in Figure 1–4. We ship the drive with the Operation Mode jumpers set to
operate correctly with your system.
CAUTION: SCSI tape drives are susceptible to mechanical and electrostatic
shock. When handling a DDS-DC drive, always wear the static-
grounding wrist strap that comes in the DDS-DC drive kit, and al-
ways handle the drive carefully.
Electrostatic charges can damage drives. To prevent such damage
from occurring, observe the following precautions during unpack-
ing and installation:
If you need to change the DDS-DC drive address or operation mode, follow these
instructions, referring to Figures 1–3 and 1–4:
1.
Locate the jumpers at the back of the DDS-DC drive.
2.
To change the jumper settings, use needlenose pliers to set the drive's SCSI ID to an
address that is not used by another SCSI device. Check that the other jumpers are set
correctly.
Stand on a static-free mat.
Wear a static strap to ensure that any accumulated electrostatic
charge discharges from your body to ground.
Connect all equipment together, including the static-free mat,
static strap, routing nodes, and peripheral units.
Keep uninstalled DDS-DC drives in their protective antistatic
bags.
Introduction
1–7