Ipv6 Address - HP 6125XLG Command Reference Manual

Default
The management Ethernet interface has no IPv4 gateway configured.
Views
Management Ethernet interface view
Parameters
ip-address: Specifies an IPv4 gateway address in dotted decimal notation.
Usage guidelines
When the device needs to communicate with a device on a remote IPv4 network, you must specify an
IPv4 gateway for the management Ethernet interface.
The IPv4 gateway address must be on the same segment as the IPv4 address of the management Ethernet
interface.
Changing or removing the IPv4 address of the management Ethernet interface removes the port's IPv4
gateway configuration.
If you execute this command multiple times, the most recent configuration takes effect.
Examples
# Configure the management Ethernet interface to use IPv4 gateway 192.168.1.5.
<boot> system-view
[boot] interface m-eth0
[boot-m-eth0] ip gateway 192.168.1.5

ipv6 address

Use ipv6 address to assign an IPv6 address to the management Ethernet interface.
Use undo ipv6 address to restore the default.
Syntax
ipv6 address ipv6-address prefix-length
undo ipv6 address
Default
The management Ethernet interface has no IPv6 address.
Views
Management Ethernet interface view
Parameters
ipv6-address: Specifies an IPv6 address.
prefix-length: Specifies a prefix length in the range of 1 to 127.
Usage guidelines
The management Ethernet interface can have only one IPv6 address. If you execute this command
multiple times, the most recent configuration takes effect.
When the management Ethernet interface is manually shut down, assigning it an IPv6 address or
removing its IPv6 address activates it at the same time.
197