Display Transceiver Interface - HP 6125XLG Command Reference Manual

Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface [ interface-type interface-number ]: Specifies an interface by its type and number. If no interface
is specified, this command displays the current measured values of the digital diagnosis parameters for
the transceiver modules on all interfaces.
Usage guidelines
This command cannot display information for some transceiver modules.
Examples
# Display the current measured values of the digital diagnosis parameters for the transceiver module on
interface Ten-GigabitEthernet 1/1/5.
<Sysname> display transceiver diagnosis interface ten-gigabitethernet 1/1/5
Ten-GigabitEthernet1/1/5 transceiver diagnostic information:
Current diagnostic parameters:
Temp(°C)
36
Table 26 Command output
Field
transceiver diagnostic information
Current diagnostic parameters
Temp.(°C)
Voltage(V)
Bias(mA)
RX power(dBm)
TX power(dBm)

display transceiver interface

Use display transceiver interface to display the key parameters of transceiver modules.
Syntax
display transceiver interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Voltage(V) Bias(mA)
3.31 6.13
Description
Digital diagnosis information of the transceiver module on the interface.
Current diagnosis parameters.
Digital diagnosis parameter—Temperature, in °C, accurate to 1°C.
Digital diagnosis parameter—Voltage, in V, accurate to 0.01 V.
Digital diagnosis parameter—Bias current, in mA, accurate to 0.01 mA.
Digital diagnosis parameter—RX power, in dBm, accurate to 0.01 dBm.
Digital diagnosis parameter—TX power, in dBm, accurate to 0.01 dBm.
RX power(dBm) TX power(dBm)
-35.64 -5.19
164