Command - HP 6125XLG Command Reference Manual

minus: Decreases the UTC time by a specified offset.
zone-offset: Specifies an offset to the UTC time, in the format hh:mm:ss. The hh value is in the range of 0
to 23, the mm value is in the range of 0 to 59, and the ss value is in the range of 0 to 59. The leading
zero in a segment can be omitted. If the seconds segment is 0 (hh:mm:00), you can omit it. If both the
minutes and seconds segments are 0 (hh:00:00), you can omit both of the segments. For example, to
specify 08:00:00, you can enter 8.
Usage guidelines
The local time zone, together with the UTC time and daylight saving time, determines the system time.
You can use the display clock command to view the system time.
A correct system time setting is essential to network management and communication. Set the system time
correctly or use NTP to synchronize your device with a trusted time source before you run it on the
network.
Examples
# Set the name of the local time zone to Z5, and add 5 hours to the UTC time.
<Sysname> system-view
[Sysname] clock timezone Z5 add 5
Related commands
clock datetime
•
• clock summer-time
display clock
•

command

Use command to assign a command to a job.
Use undo command to revoke a command.
Syntax
command id command
undo command id
Default
No command is assigned to a job.
Views
Job view
Predefined user roles
network-admin
Parameters
id: Specifies a command ID in the range of 0 to 4294967295.
command: Specifies the command to be assigned to the job.
Usage guidelines
A job can have multiple commands. Commands in a job are uniquely identified by their IDs. A command
with a smaller ID is executed earlier.
147