Table of Contents
Advertisement
Connections
Connecting a RGB Analog source to port 3
Connect your RGB source via an interface to Port 3.
Note :
If a line doubler or line multiplier is built in, the default position of this line doubler (multiplier) soft option is ON (active). The video input
signal will be displayed as a non interlaced image (= improved image stability).
To enable or to disable this function, enter the adjustment mode and change the position of the ON/OFF toggle switch (see chapter
'Random access' adjustment mode).
Always use an interface when a computer and local monitor have to be connected to the projector.
BARCO's Interface units.
Universal analog interface
RGB 120 MHz Analog Interface
Multifunctional Analog Interface Kit
(MAGIK)
VGA interface
MAC interface
' Ã ƒr …v ƒ ur … hy †
POWER / MA INS
COMM. PO RT
Pin configuration D9 connector of the Analog input.
1
Not connected
2
Ground RGBS
3
RED
4
GREEN
5
BLUE
6
Ground RGBS
7
Ground RGBS
8
Hor/comp. sync
9
Vert. sync
Input selection
With the RCU or built-in RCU : press digit button 3
Locations of the Termination Resistors and Switches on the RGB Input Auto Sync Tracking Module
When changing a switch position or removing a resistor, turn off the projector and unplug the power cord from the wall outlet.
75 W Termination resistors
In case of chaining (loop-through) the projectors, the 75W line termination resistors must be removed from the RGB Input Auto Sync
Tracking Module when the projector is NOT the last unit in the chain.
In case of a stand-alone projector, do not remove the resistors.
6-4
R9826100
R9826570 (230V)
R9828120 (230V)
R9828129 (120V)
R9828070 (230V)
R9828079 (120V)
R9828050 (230V)
R9828059 (120V)
PO RT 4/5
PO RT 2
P ORT 3
&$ Âu €Ã ‡r…€
LQ Y HU
PORT 1
PROJECTOR MODE
5976066 BARCOCINE 8 10022000
Advertisement
Table of Contents
