Connecting A Rgb Analog Source To Port 3 - Barco R9002040 Instruction Manual

Connecting a RGB Analog source to port 3.

Connect your RGB source via an interface to Port 3.
Always use an interface when a computer and local monitor have to
be connected to the projector.
Barco interfaces which can be applied :
Universal analog interface
RGB 120 MHz analog interface R9826570
VGA interface 120V
230V
MAC interface 120V
230V
MAGIK interface 120V
230V
RGB analog input with automatic sync detection. (Separate H and
V sync inputs, with composite sync input or with sync signals on
green)
Pin configuration D9 connector of the Analog input.
1 not connected
2 ground RGBS
3 RED
4 GREEN
5 BLUE
6 ground RGBS
7 ground RGBS
8 Hor/comp. sync
9 Vert. sync
Analog Input Selection :
with the RCU or build in RCU, press digit button 3.
Locations of the Termination Resistors and Switches
When changing a switch position or removing a resistor, turn off the
projector and unplug the power cord from the wall outlet.
75 Ω Ω Termination resistors
In case of chaining (loop-through) the projectors, the 75Ω line
termination resistors must be removed from the RGB Input Auto Sync
Tracking Module when the projector is the last unit in the chain.
In case of a stand-alone projector, do not remove the resistors.
75 Ω resistors on the module : line terminated.
75 Ω resistors removed
Procedure to remove the line termination resistors :
Turn off the projector and unplug the projector power cord.
Put the projector in service position 2 (see p.5-2).
Take out the RGB Input Auto Sync Tracking Module from the main
frame.
Unsolder and remove the resistors.
To take out the RGB Input Auto Sync Tracking Module :
press the module lock and lift up the module handle;
Top view
Top view
repeat this action on both sides of the module and extract the
module out of the main frame.
5975537 RETROGRAPHICS 808s 060197
R9826100
R9828079
R9828070
R9828059
R9828050
R9828129 & R9828128
R9828120 & R9828121
: line not terminated.
Side view
Side view
L
RS232 IN RS232 OUT IR REMOTE R
R101
Vsync
R81
Hsync
R41
R21
(Blue)
(Green)
Line termination 75 Ω resistors
RGB Input Auto Sync Tracking Module
Source Connections
R L
PORT 4/5
ANALOG INTERF. 120MHz
ON
INPUT
B H
OFF
G
R
75 o h m t erm.
S2 Blue in Green (ON=yes)
S1 Force Negative Sync
R1
(Red)
V
INP INP
in ver.
(ON=yes)
6 - 3