Connecting a Component source.
(R-Y)Y(B-Y) analog input terminals with sync input or with sync on the luminance (Y) input. The projector detects automatically where
the sync signal is located.
Line doubling or multipling is possible for component video input sources on standard line frequency.
Note :
If a line doubler or line multiplier is built in, the default position of this line doubler (multiplier) soft option is ON (active). The video input
signal will be displayed as a non interlaced image (= improved image stability).
To enable or to disable this function, enter the adjustment mode and change the position of the ON/OFF toggle switch (see chapter
'Random access' adjustment mode).
(R-Y)Y(B-Y)S or (R-Y)Ys(B-Y) input selection (component video input)
With the RCU or built-in RCU : press digit button 6
' Ã r
v ur
hy
P OWE R / MA INS
COMM. PO RT
Connecting a Component source with Tri-level sync.
(R-Y)Y(B-Y) analog input terminals with Tri-level sync input or with Tri-level sync on the luminance input.
(R-Y)Y(B-Y)3S or (R-Y)Y3s(B-Y) input selection
' Ã r
v ur
hy
P OWER / MA INS
COMM. PO RT
RS232 Connection
RS232 input and RS232 output of the projector.
The projector is equipped with a RS232 port that allows it to communicate with a computer.
Applications
a) remote control:
- easy adjustment of the projector via IBM PC (or compatible) or MAC connection.
- allow storage of multiple projector configurations and set ups.
- wide range of control possibilities.
- address range from 0 to 255.
b) data communications:
- sending data to the projector or copying the data from the projector to a hard memory device.
5976065 BARCOCINE 8 10022000
PO RT 4/5
PO RT 2
P ORT 3
8 vrÃ
vqr
PO RT 4/5
PO RT 2
P ORT 3
8 vrÃ
vqr
P ORT 1
P ROJECTOR MODE
6qvÃP
P ORT 1
P ROJE CTOR MODE
6q vÃP
Connections
6-7