Connecting A Rgb Analog Source To Port 3; Connecting A Rgb Analog Source To Port 4/5 - Barco R9002031 Owner's Manual

Connections

Connecting a RGB Analog source to port 3.

Connect your RGB source via an interface to Port 3.
Always use an interface when a computer and local monitor have to
be connected to the projector.
Available Barco interfaces :
Universal analog interface
RGB 120 MHz analog interface R9826570
VGA interface 120V
230V
MAC interface 120V
230V
MAGIK interface 120V
230V
RGB analog input with automatic sync detection. (Separate H and
V sync inputs, with composite sync input or with sync signals on
green)
Pin configuration D9 connector of the Analog input.
1 Not connected
2 Ground RGBS
3 RED
4 GREEN
5 BLUE
6 Ground RGBS
7 Ground RGBS
8 Hor/comp. sync
9 Vert. sync
Analog Input Selection :
Press digit button 3 on the RCU or the local keypad.

Connecting a RGB Analog source to port 4/5.

RGB analog input terminals with separate H and V sync inputs,
composite sync input or sync signals on green (automatic sync
detection).
Always use an interface when a computer and local monitor have to
be connected to the projector. See 'Connecting a RGB Analog
source to port 3' for a list of BARCO interfaces which can be applied.
RGB input selection :
(RGB : R, G, B signals with automatic sync detection)
Press digit button 4 or 5 on the RCU or the local keypad.
3-4
R9826100
R9828079
R9828070
R9828059
R9828050
R9828129 & R9828128
R9828120 & R9828121
See installation instructions b efore connecting to the supply.
Voir la not ice d'in stallat ion ava nt de r accorder au rés eau.
12 0/2 30 V
7/5 Amp
50/60 Hz
PORT 4/5
ANALOG INTERF. 120MHz
ON
INPUT
B H V
OFF
R G
INP INP
75 o h m t erm. in ver.
See installa tion ins tructio ns befor e conne cting to the sup ply.
Voir la notice d'installation avant de raccorder au réseau.
12 0/2 30 V
7/5 Amp
50/60 Hz
PORT 4/5
ANALOG INTERF. 120MHz
ON INPUT
B H
OFF
G
R
INP
75 ohm term.
This device complies with part 15 of
the FCC rules. Operation is subje ct to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this dev ice must
accept any interference received
including inte rference that may cause
undesire d operation"
75 Ohm 7 5 Ohm
PORT 2
361
This device compli es with part 15 of
the FCC rules. Operation is subject to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this device must
accept any interf erence received
including interfere nce that may cause
unde sired operation"
7 5 Ohm 7 5 Ohm
POR T 2
V
INP
inver.
363
5975597 BARCODATA 808S 110397