Table of Contents
Advertisement
Vertical Scan Switch
One vertical switch is used for the three CRT's. See position of the switch (diagrams) for the corresponding projector configuration.
To set the vertical scan switch :
•
Remove the vertical deflection module (the third module viewing from the rear of the projector).
To remove the vertical deflection module :
- Press the module lock and lift up the module handle;
- Repeat this action on both sides of the module and extract the module out of the main frame.
•
Toggle the vertical scan inversion switch to the correct position.
•
Reinstall the vertical deflection module.
Positioning the scan switches for the different mounting configurations
Positions of the scan switches for the different mounting configurations are illustrated below.
3-6
Vertical scan switch
Connectors for the vertical
deflection module
Vertical deflection module
5976065 BARCOCINE 8 08022000
Advertisement
Table of Contents
