Connecting A Rgb Analog Source To Port 3; Connecting A Rgb Analog Source To Port 4/5 - Barco R9000901 Owner's Manual

Connections

Connecting a RGB Analog source to port 3.

Connect your RGB source via an interface to Port 3.
Always use an interface when a computer and local monitor have to
be connected to the projector.
Barco interfaces which can be applied :
Universal analog interface
RGB 120 MHz analog interface R9826570
VGA interface 120V
230V
MAC interface 120V
230V
MAGIK interface 120V
230V
RGB analog input with automatic sync detection. (Separate H and
V sync inputs, with composite sync input or with sync signals on
green)
Pin configuration D9 connector of the Analog input.
1 not connected
2 ground RGBS
3 RED
4 GREEN
5 BLUE
6 ground RGBS
7 ground RGBS
8 Hor/comp. sync
9 Vert. sync
Analog Input Selection :
with the RCU or build in RCU, press digit button 3.

Connecting a RGB Analog source to port 4/5.

RGB analog input terminals with separate H and V sync inputs, with
composite sync input or with sync signals on green (automatic sync
detection).
Always use an interface when a computer and local monitor have to
be connected to the projector. See 'Connecting a RGB Analog
source to port 3' for a list of BARCO interfaces which can be applied.
RGB input selection :
(RGB : R, G, B signals with automatic sync detection)
with the RCU or the build in RCU : press digit
button 4 or 5
3-4
R9826100
R9828079
R9828070
R9828059
R9828050
R9828129 & R9828128
R9828120 & R9828121
See installation instructions b efore connecting to the supply.
Voir la not ice d'in stallat ion ava nt de r accorder au rés eau.
12 0/2 30 V
7/5 Amp
50/60 Hz
PORT 4/5
ANALOG INTERF. 120MHz
ON
INPUT
B H
V
OFF
G
R
INP
75 o h m t erm.
See installa tion ins tructio ns befor e conne cting to the sup ply.
Voir la notice d'installation avant de raccorder au réseau.
12 0/2 30 V
7/5 Amp
50/60 Hz
PORT 4/5
ANALOG INTERF. 120MHz
ON
INPUT
B H
OFF
R G
INP
75 ohm term.
5975007 BARCOGRAPHICS 808S 051196
This device complies with part 15 of
the FCC rules. Operation is subje ct to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this dev ice must
accept any interference received
including inte rference that may cause
undesire d operation"
75 Ohm 7 5 Ohm
PORT 2
INP
in ver.
361
This device compli es with part 15 of
the FCC rules. Operation is subject to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this device must
accept any interf erence received
including interfere nce that may cause
unde sired operation"
7 5 Ohm 7 5 Ohm
POR T 2
V
INP
inver.
363