Table of Contents
Advertisement
Projector setup
The communication speed between the projector and the computer has 8 possible settings. With DIP Switch No. 6, No.7 and No.8
of the 8 DIP switches on the controller board, labelled as 'Baud rate code (sum)', it is possible to select the baud rate (communication
speed). Each DIP switch has its own decimal value. The sum of the values associated to those DIP switches gives the baud rate
code. Each baud rate code corresponds an communication speed.
Position of DIP switches and baud rate codes :
Binary Baud rate code
000
0
001
1
010
2
011
3
100
4
101
5
110
6
111
7
Factory preset baud rate = 9600
Baud rate
DIP switches
More information about computer communication with the projector is available in the Projector Control Software manual.
With DIP Switch No.5 of the second set of 8 DIP switches on the controller board, the projector adjustments can be protected with
a password. When the password feature is enabled, the user has to enter a password before he can enter the adjustment mode
(For more information about password setting and reprogramming the password, see Installation Adjustment).
When the password menus are disabled (adjust mode is unprotected), the adjust mode can be selected by pressing the <ADJUST>
key. This position of the DIP switch is useful for qualified service technicians because they do not need a password to enter the adjust
mode.
Position of DIP Switch No.5 :
ON :
OFF
Factory preset password mode : OFF.
0
Password
mode
OFF ON
4-4
Speed
110
150
300
600
1200
2400
4800
9600
0
1
1
2
3
4
5
6
4
7
2
1
8
OFF ON
password mode enabled.
:
password mode disabled.
1
1
2
3
4
5
6
7
8
5976065 BARCOCINE 8 08022000
Advertisement
Table of Contents
