Connecting A Composite Video Source; Connecting A S-Video Or Video Source To Port 2 - Barco Cine 8 Manual

Connections

Connecting a Composite Video source.

Composite video signals from a VCR, OFF air signal decoder, etc..
Note :
If a line doubler or line multiplier is built in, the default position of this line doubler (multiplier) soft option is ON (active). The video input
signal will be displayed as a non interlaced image (= improved image stability).
To enable or to disable this function, enter the adjustment mode and change the position of the ON/OFF toggle switch (see chapter
'Random access' adjustment mode).
'  Ã ƒr …v ƒ ur …hy †
POWER / MAINS COMM. PO RT
Video input selection :
With the RCU or built-in RCU : press digit button 1
Note
When using the loop-through Video output, then set the termination switch to the 'OFF' position.
75 W Termination Switch for Video
Terminate the video input of the projector using the 75 W switch next to the video input, when the projector operates alone or when
the projector is the last unit in loop-through configuration.
The switch is set to 'ON' : signal terminated
The switch is set to 'OFF' : signal not terminated.

Connecting a S-Video or Video source to port 2.

Separate Y-luma/C-chroma signals for higher quality playback of Super VHS signals.
Note :
If a line doubler or line multiplier is built in, the default position of this line doubler (multiplier) soft option is ON (active). The video input
signal will be displayed as a non interlaced image (= improved image stability).
To enable or to disable this function, enter the adjustment mode and change the position of the ON/OFF toggle switch (see chapter
'Random access' adjustment mode).
'  Ã ƒr …v ƒ ur …hy †
P OWE R / MA INS COMM. PO RT
6-2
PO RT 4/5 PO RT 2
PORT 3
8‚€ƒ‚†v‡rÃ
‰vqr‚
PO RT 4/5 PO RT 2
P ORT 3
PORT 1 PROJECTOR MODE
‡‚Ár‘‡Ãƒ…‚wrp‡‚…
‚…Ç‚ÃhÀ ‚v‡‚…
6ˆqv‚ÃPˆ‡
P ORT 1 P ROJECTOR MODE
5976066 BARCOCINE 8 10022000