Juniper MX240 Hardware Manual page 229

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
Insert the other end of the cable into the destination port.
4.
Repeat the previous steps for any additional cables.
5.
If the component is offline (its failure indicator LED is lit), use one of the following
6.
methods to bring the PIC online:
To bring a DPC or an MPC online:
Press and hold the corresponding online button on the craft interface until the
green LED next to the button lights steadily, in about 5 seconds.
OK
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the Junos OS Operational Mode
Commands.
To bring a PIC online:
Press the PIC offline/online button until the PIC LED lights green. For a PIC installed
in FPC3, use a narrow-ended tool that fits inside the opening that leads to the
button.
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the Junos OS Operational Mode
Commands.
To bring a MIC online:
Press the MIC offline/online button until the PIC LED lights green.
Issue the following CLI command:
user@host>request chassis mic fpc-slot mpc-slot pic-slot mic-slot online
For more information about the command, see the Junos OS Operational Mode
Commands.
The normal functioning indicator LED confirms that the component is online. You can
also verify correct DPC or MPC functioning by issuing the
or correct MIC or PIC functioning by issuing the
Preventing Electrostatic Discharge Damage to an MX240 Router on page 226
Maintaining MX240 PICs on page 125
Troubleshooting the MX240 PICs on page 147
MX240 PIC Serial Number Label on page 296
MX240 PIC Description on page 17
Replacing an MX240 FPC on page 184
Chapter 14: Replacing MX240 Hardware Components
show chassis fpc
show chassis fpc pic-status
command
.
205