When Other Messages Appear - Ricoh MP C2003 Series User Manual

When Other Messages Appear

Messages
"Cannot connect with the
wireless card. Turn the main
power switch off, then check
the card."
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless
card".)
"Cannot connect with the
Bluetooth interface. Check
the Bluetooth interface."
"Clean the scanning glass.
(Located next to the
exposure glass.)"
"Following output tray is full.
Remove paper."
"Internal cooling fan is
active."
Causes
• The wireless LAN
board was not inserted
when the machine was
turned on.
• The wireless LAN
board was pulled out
after the machine was
turned on.
• The settings are not
updated although the
unit is detected.
• The Bluetooth interface
unit was installed while
the machine was turned
on.
• The Bluetooth interface
unit was removed while
the machine was turned
on.
The scanning glass or guide
plate of the ADF is dirty.
The output tray is full.
Large print runs will cause
the machine's interior to heat
up, triggering the cooling
fan.
When Other Messages Appear
Solutions
Turn off the power, and then confirm
the wireless LAN board is inserted
correctly. After confirmation, turn on
the power again. If the message
appears again, contact your service
representative.
Turn off the power, and then confirm
that the Bluetooth interface unit was
installed correctly. After confirmation,
turn on the power again. If the
message appears again, contact your
service representative.
Clean them. See "Maintaining Your
Machine", Maintenance and
Specifications.
Remove paper from the output tray to
resume printing.
The fan will emit noise, but this is
normal and the machine will be
operable while the fan is running.
The amount of paper that can be
printed and the total operation time
until the fan starts running depends on
the temperature of the location at
which the machine is installed.
225