Using The Server Function - Ricoh PJ WX4141n Operating Instructions Manual

Using the Server Function

The projector can access the projection server and the DLNA-compatible devices via a network to
project files stored on them. The projector can project still images by using its server function. The
projector can also project videos stored on DLNA-compatible devices if DLNA certification mode is
disabled. The supported file types for the projection server and the DLNA-compatible devices are shown
below:
Still images (Projection server/DLNA-compatible devices)
Item
File extensions
File size
Number of pixels
File format
Videos (DLNA-compatible devices)
Item
File extensions
Number of pixels
Video compression format
Audio compression format
Container format
Frame rate
Bit rate
To project a file on the server, you must configure the required settings for the projector and the server.
For details about the settings for using the projection server function, see page 76 "Using the
Projection Server Function". For details about the settings for using the DLNA server function, see
page 78 "Using the DLNA Server Function".
• The supported video file types are compliant with the projector's own specifications. They are not
compliant with the DLNA 1.5 guidelines.
• The maximum number of files that can be displayed in the list is 512 per folder.
jpg, jpeg, JPG, JPEG
Less than 10 MB
2 × 2 to 5120 × 5120 pixels
Baseline format
mpg, mpeg, MPG, MPEG, m2ts, m2t, M2TS, M2T, m2p, M2P
320 × 240 to 1280 × 720 pixels
MPEG2
MPEG1/2-Audio Layer2, Linear PCM
MPEG2-PS, MPEG2-TS
Less than 30 fps
Less than 15 Mbps (recommended)
Using the Server Function
Requirement
Requirement
75