Configuring The Wireless Lan Settings For Ad Hoc Mode - Ricoh PJ WX4141n Operating Instructions Manual

4. Enter the network key.
When connecting to a network for which a network key is not set, the network key input screen is
not displayed. Proceed to Step 5.
5. Select [Disable DHCP (Manual Settings)] or [Enable DHCP (Auto Settings)], and then press
the [Enter] button.
If you select [Enable DHCP (Auto Settings)], proceed to Step 9.
6. Specify the projector's IP address.
7. Specify the subnet mask.
8. Specify the default gateway.
9. Select [OK] on the confirmation screen, and then press the [Enter] button.
To project a computer's screen, see page 73 "Projecting a Computer's Screen Using
QuickProjection".

Configuring the Wireless LAN Settings for Ad Hoc Mode

1. Select [Wireless LAN (Adhoc)] on Network Setting Wizard, and then press the [Enter]
button.
The network settings are configured automatically.
2. Select [OK] on the confirmation screen, and then press the [Enter] button.
To project a computer's screen, see page 73 "Projecting a Computer's Screen Using
QuickProjection".
Connecting the Projector to a Network
71