Opening Network Setting Wizard; Configuring The Wired Lan Settings - Ricoh PJ WX4141n Operating Instructions Manual

5. Using the Projector via a Network

Opening Network Setting Wizard

You can open Network Setting Wizard on the menu screen.
1. Press the [Menu] button.
2. Select [Network/USB Settings], and then press the [ ] button.
3. Select [Network Settings], and then press the [Enter] button.
4. Select [Setup Wizard], and then press the [ ] button.
5. Select [Network Setting Wizard], and then press the [Enter] button.
Network Setting Wizard appears.

Configuring the Wired LAN Settings

Connect an Ethernet cable to the projector before configuring the settings.
Contact your network administrator for the information required for configuring network settings.
1. Select [Wired LAN] on Network Setting Wizard, and then press the [Enter] button.
2. Select [Disable DHCP (Manual Settings)] or [Enable DHCP (Auto Settings)], and then press
the [Enter] button.
If you select [Enable DHCP (Auto Settings)], proceed to Step 6.
3. Specify the projector's IP address.
4. Specify the subnet mask.
68